Full-Screen Logon for a RACF-Defined User
If you are a RACF-defined user, and this is your first logon using the full-screen logon panel:
- Enter
LOGON yourid
. TSO/E displays the following panel with default values:------------------------------- TSO/E LOGON ---------------------------------- PF1/PF13 ==> Help PF3/PF15 ==> Logoff PA1 ==> Attention PA2 ==> Reshow You may request specific HELP information by entering a '?' in any entry field. ENTER LOGON PARAMETERS BELOW: RACF LOGON PARAMETERS: USERID ===> YOURID SECLABEL ===> PASSWORD ===> - NEW PASSWORD ===> PROCEDURE ===> MYPROC GROUP IDENT ===> ACCT NMBR ===> 00123 SIZE ===> 5800 PERFORM ===> COMMAND ===> EXEC (SETUP) ENTER AN 'S' BEFORE EACH OPTION DESIRED BELOW: -NOMAIL -NONOTICE -RECONNECT -OIDCARD
- Enter your password (commonly a group password) in the PASSWORD field. If you want to change your password, enter the new password in the NEW PASSWORD field. You may also enter other logon operand values.
- Press the Enter key to enter your input to TSO/E. After preliminary
messages, TSO/E generally displays three asterisks,
***
. Whenever you see ***, press the Enter key to continue. You then see the READY message:READY
If you specified a command in the COMMAND field of the logon panel, in this case, EXEC (SETUP), TSO/E processes your command. Had you left the COMMAND field blank, you could begin entering commands immediately after the READY message.
- Note: The SECLABEL field on the full-screen logon panel is displayed only if your installation is using security labels.
When you log on to TSO/E using the full-screen logon panel, the values that are shown in some of the fields, such as PROCEDURE, ACCT NMBR, and SECLABEL are the values that you entered for your previous TSO/E session. You can choose a different value by typing in a new value in the field. The new value that you enter is then saved and is displayed whenever you log on again until you either enter a different value or blank out the field.
- If PasswordPrePrompt is active, you are prompted for your password before the display of the full-screen panel.
The values that you are required to enter on the logon panel depend on your installation. See your TSO/E administrator for logon instructions.