Issuing the ARECOVER command when using NetView FTP

When you use NetView® FTP to transmit aggregate backup files, the following steps must be taken before you issue the ARECOVER command:

1. Ensure that all control file and data file data sets and any accompany data sets are cataloged before issuing the ARECOVER command.
2. Use the XMIT parameter on the ARECOVER command to indicate you are recovering data sets that have been transferred using NetView FTP.
3. Do not specify the UNIT and VOLUME parameters when XMIT is specified on the ARECOVER command, as shown in this example:

   ARECOVER PAY1.C.C01V0001 REPLACE XMIT

4. Do not use the AGGREGATE parameter with the XMIT parameter.