AOP198EAOPCMND failed with diagnostic_data.
AOPCMND failed with diagnostic_data.
Explanation
There was an error in processing the AOPCMND command, probably because another service routine failed. The diagnostic_data describes the cause of the failure.System action
The requested XCF signal is not sent to the XCF daemon.Operator response
Notify the system programmer or administrator that this error occurred.
System programmer response
If you cannot correct the problem, contact your service representative in the IBM® Support Center, or use your electronic link with IBM service for assistance.User response
None.
Problem determination
If diagnostic_data begins with IXCxxxxx, see z/OS MVS Programming: Sysplex Services Reference under the description of the named macro for an explanation of the return code and reason code.
If diagnostic_data begins with IKJSCAN or IKJPARS, see z/OS TSO/E Programming Services for an explanation of the return code and reason code.
Module
Not applicable.
Source
The TSO/E AOPCMND command.
Routing code
Not applicable.
Descriptor code
Not applicable.
Automation
Not applicable.