IEC161I (return code 037)   rc[(sfi)]-ccc,jjj, sss,ddname,dev,ser,xxx, dsname,cat

Explanation

For general information about message IEC161I, see the explanation for return code 001.

Specific information for this return code: The catalog routines returned an unexpected return code. The (sfi) field in the message is of the form (rc, crs, cmi) where
  • rc - catalog return code
  • crs - catalog reason code
  • cmi - catalog module name that detected the error
See message IDC3009I for a list of these catalog return and reason codes.
  • ccc = 217 - Preformat call to update catalog failed.
  • ccc = 220 - Call to striping extend RC = 12, RSN = 1. First catalog locate had an error.
  • ccc = 223 - Call to striping extend RC = 12, RSN = 2. Set VVRIF had an error.
  • ccc = 224 - Call to striping extend RC = 12, RSN = 3. Third catalog call (extend) had an error.
  • ccc = 227 - Call to striping extend RC = 12, RSN = x. Unknown error. Call to extend had an error.

System action

OPEN, CLOSE, or EOV processing ends for the data set. CLOSE (TYPE=T operand) processing continues, if possible. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 148 (X'94').

Programmer response

If the error occurred during OPEN, CLOSE (TYPE=T), or EOV processing, rerun the job. If the error persists, restore the catalog and all volumes controlled by the catalog from synchronized restore tapes. If the error occurred during CLOSE processing, and the data set was open for output processing, use the access method services VERIFY command to ensure that the end-of-file marker is properly addressed in the data set's entry in the catalog; then rerun the job. If the problem persists, restore the catalog and all volumes controlled by it from synchronized restore tapes.

Module

IDA0192C, IDA0557B, IDA0557E, IDA0557X, IDAV192C, IDAV557A, IDAV557X

Routing code

11

Descriptor code

6

Parent topic: IEC messages