IEC161I (return code 034) rc[(sfi)]-ccc,jjj, sss,ddname,dev,volser,xxx,dsname,cat
Explanation
For general information about message IEC161I, see the explanation for return code 001.
Specific information for this return code: The maximum relative byte address (RBA) limit (4,294,967,295) has been reached.
The subfunction information field, if present, contains a decimal problem-determination code (reason code) for use by the IBM® Support Center in case further problem diagnosis is necessary. The following table lists the reason codes for return code 034.
SFI Decimal Value | Description |
---|---|
004 | End of volume - Non-extended addressable. The new allocation amount would exceed 4 GB. |
005 | End of volume - Extended addressable. The new allocation amount would cause the number of control intervals to exceed hexadecimal X'FFFFFFFF'. |
014 | End of volume - Both the PRIMARY allocation amount and the SECONDARY allocation amount would cause the maximum RBA to be exceeded. |
015 | End of volume - Guaranteed space. The PRIMARY or SECONDARY space allocation would cause the maximum RBA to be exceeded. |
016 | End of volume - The PRIMARY allocation amount would cause the maximum RBA to be exceeded. |
- (rc, crs, cmi)
- rc
- The catalog return code.
- crs
- The catalog reason code.
- cmi
- The name of the catalog module that detected the error.
See message IDC3009I for a list of these catalog return and reason codes.
System action
EOV processing ends for the data set.
System programmer response
Use the access method services REPRO command to make a backup copy of the cluster that contains the data set. Delete the cluster from the catalog with the DFSMS DELETE command. Redefine the cluster with extended format and extended addressability.
Module
IDA0557B, IDAV557A, IDA0557E
Routing code
11
Routing code
11
Descriptor code
6
Descriptor code
6