IEC161I (return code 028) rc[(sfi)]-ccc,jjj, sss,ddname,dev,ser,xxx, dsname,cat
Explanation
For general information about message IEC161I, see the explanation for return code 001.
- rc - catalog return code
- crs - catalog reason code
- cmi - catalog module name that detected the error
See message IDC3009I for a list of these catalog return and reason codes.
System action
OPEN, CLOSE, or EOV processing ends for the data set. CLOSE (TYPE=T operand) processing continues, if possible. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 180 (X'B4').
Programmer response
If the error occurred during OPEN, CLOSE (TYPE=T), or EOV processing, make sure that the correct catalog is available (for example, volume is online) and rerun the job. If the error occurred during CLOSE processing, make sure that the correct catalog was not deleted and is open. If the data set was open for output, use the access method services VERIFY command to make sure that the end-of-file marker in the data set entry in the catalog is correct. Do this before trying any further processing on the data set. If the data set was open for input, the VERIFY command need not be used.
Module
IDA0192C, IDA0557A, IDA0557B, IDAV192C, IDAV557A
Routing code
11
Descriptor code
6