IEC172I dev OPERATOR CANCELED text REQUEST
Explanation
- FCB imageid VERIFY
- FORMS OVERLAY
- RETHREAD
- Message IEC128D, requesting that the operator verify the alignment of forms to the forms control buffer image; imageid is the one to four-character identifier specified for the image on the FCB operand of the SETPRT macro instruction.
- Message IEC163A, asking that the operator load a forms overlay frame.
- Message IEC164A, asking that the operator change the paper threading.
- dev
- The device number of the specified device.
System action
SETPRT processing ends and places a return code in register 15.
Operator response
If you decide that you should not have replied CANCEL to message IEC128D, IEC163A, or IEC164A, rerun the job that issued the SETPRT macro instruction. If you tried to perform the action requested by message IEC128D, IEC163A, or IEC164A but you could not, or if you think that the message was issued because of a programming error, notify the programmer whose job issued the SETPRT macro instruction.
Programmer response
If the operator tried to perform the action requested by message IEC128D, IEC163A, or IEC164A, but could not, determine why the operator could not perform the action and correct the problem. If it appears that the system should not have issued message IEC128D, IEC163A, or IEC164A, there is probably an error in the values specified for the 3800 printer parameters in the JCL or on the SETPRT macro instruction.
Source
DFSMSdfp
Module
IGG08113