IEC514D   DCK OR LBL ERR, dev,ser,jjj,sss [,dsname]

Explanation

One of the following caused the error:
  • During tape volume verification, a data check occurred in open or end of volume (EOV) processing.
  • The wrong volume (label type or volume serial number) was mounted.

In both cases the mount request is for a specific labeled tape volume. When the error is for a label, two specific mount requests have previously been issued for the volume specified by ser.

In the message text:
dev
The device number of the specified device.
ser
The volume serial number.
jjj
The job requesting the volume.
sss
The job step requesting the volume.
dsname
Appears when a MONITOR DSNAME command is active to indicate the data set requesting the volume.

System action

The job step waits for the operator to reply or until the task reaches the maximum time limit.

Operator response

Reply M for open or EOV processing to continue to process the mounted volume. If another data check or label error is detected, this may result in a volume demount followed by another MOUNT request for the volume specified by ser.

Reply A to abend the task, abend X'413' with a return code of X'OC' for OPEN processing, abend X'637' with a return code of X'34' for EOV processing. The abend option provides an alternative to cancelling the job when the specific labeled tape mount request cannot be satisfied.

Note: If the message is issued because of a data check, and if writing to file sequence 1, the label editor routines can be entered to allow relabeling the volume.

Source

Data Facility Product (DFP)

Parent topic: IEC messages