IEC522I dev,jjj,sss,ser Warning: Library default policy names assigned. Previous volser=volser
Explanation
During tape end-of-volume verification processing, the library was unable to assign the automatic class selection (ACS) routine construct names. All volumes of a multivolume data set are to be assigned the same policy names; however, due to an internal processing error at the library, the policy names assigned to the previous volume could not be assigned to the next volume of the multivolume data set. Consequently, the library sets policy names for the mounted volume to the default policy name.
Even though the default policy names might be associated with the volume, the default policy actions might not always be used. There are times when the library will bind policy actions (for example, logical WORM, volume size, copy modes, and so on) to the volume early in the mount process. In this case, the policy actions used by the library might be a mixture of both the requested and the default actions.
In the message text:
- dev
- The device number.
- jjj
- The job name.
- sss
- The step name.
- ser
- The volume serial number.
- volser
- The previous volume serial number.
System action
The mount proceeds with the default policy name (blanks) and actions being used for the volume. The default policy name is assigned and used for each construct. From this point forward, all volumes of the multivolume data set might not have the same policy names assigned. For further discussion of the policy actions used by the library, also see the explanation above.
Operator response
Contact your system programmer.
System programmer response
You can later use the LIBRARY LMPOLICY command to reassign policy names to the volume.
Programmer response
Contact your system programmer.
Problem determination
Contact the IBM® Support Center to determine the cause of the internal processing error at the library.
Source
DFSMSdfp