You must use a series of SETXCF commands to add a new, larger couple data set as the primary WLM couple data set. During this processing you may encounter a message from XCF (IXC250I) indicating your new couple data set is too small. The message indicates which subrecords had insufficient space. If this occurs you must reallocate the new couple data set with a larger size.
Allocate couple data set Allocate couple data set using CDS values
Service policies . . _5 Service policies . . 10
Workloads . . . . . _40 Workloads . . . . . _35
Service classes . . _35 Service classes . . _30
Application Application
environments . . . . 100 environments . . . . _50
Scheduling Scheduling
environments . . . . _80 environments . . . . _50
Then
you should use the highest values in each category, in this case 10,
40, 35, 100, and 80, to allocate your new couple data set.