Use the REPORT DEFINEDCAPACITY command to display the current Defined
Capacity management data for an LPAR. You can identify the LPAR either
by the name of the z/OS system and sysplex running in the LPAR, or
by the name of the LPAR and the name of the CPC on which the LPAR
is active. The specified system must be part of the active domain
configuration and the system must be currently observed. The specified
CPC must be part of the active domain configuration. For information
about what is contained in the report, see page The defined capacity report.
The name of the sysplex to
which the specified system belongs.
SYS=name
The name of the system for
which LPAR you want to display Defined Capacity management data. At
the HMC Defined Capacity must be turned on for the LPAR.
CPC=name
The name of the CPC on which to find the specified LPAR.
LPAR=name
The name of an LPAR for which you want to display the Defined
Capacity management data. At the HMC Defined Capacity must be turned
on for the LPAR and the system running in this LPAR must be currently
observed.
DEST=
The destination of the defined capacity
report. The following destinations are supported:
*
(Default) specifies that the report should be written to the console issuing the command.
file
Specifies a file where the information is to be stored. If the
name includes lowercase characters, this parameter must be enclosed
in single quotation marks ('). The file must be in the hierarchical
file system. You can specify either an absolute, path or a relative
path to the file. If this is not absolute the path is relative to
the home directory of the user that is running the Provisioning Manager.
You must ensure that there is sufficient space in the selected location.
The Provisioning Manager user must be authorized to write to this
location.