ENABLE POLICY

Use the ENABLE POLICY command to enable an entire provisioning rule or a specific provisioning condition within a provisioning rule in the active provisioning policy. If time conditions are enabled by this command, additional capacity can be provisioned.

If the command is successful, the selected rule or provisioning condition is listed as enabled in the policy report.

Syntax

>>-+-ENABLE--POLICY-+--R=rule_name--+-------------------+------><
   '-E--P-----------'               '-PC=condition_name-'
 

Parameters

The command has the following parameters:

R=rule_name

The name of the rule that you want to enable. The specified rule must exist in the active policy. If the name contains lowercase characters, then your console might require that the name be enclosed in quotation marks.

PC=condition_name

The name of the provisioning condition that you want to enable. A provisioning condition with the specified name must be part of the rule_name specified. If the name contains lowercase characters, then your console might require that the name be enclosed in quotation marks.

Example

To enable rule CP160106R, issue the following command:

MODIFY CPOSERV,APPL=ENABLE POLICY R=CP160106R

or:

F CPOSERV,APPL=E P R=CP160106R

The response on the console is:

CPO1001I Rule CP160106R successfully enabled