The domain report

To create a domain report, issue a REPORT DOMAIN command. For the syntax of this command, see page REPORT DOMAIN . The report contains information about the current setup of the domain managed by the Provisioning Manager. The information is listed in the following order, and includes:

The name of the provisioning domain and the time when the Provisioning Manager was started
The active processing mode and the time it was activated. The possible values for the processing mode are:
- MANUAL
- ANALYSIS
- CONFIRMATION
- AUTONOMIC
The active domain configuration and the time it was activated. A domain configuration name of "*none" indicates that the default domain configuration is active, because you never activated your own domain configuration. In this case, the reported time is the time when the Provisioning Manager first ran.
The name of the active provisioning policy and the time it was activated. A policy name of "*none" indicates that the default policy is active, because you never activated your own policy. In this case, the reported time is the time when the Provisioning Manager first ran.
Service information about the code level of the running program.
If type=detailed was requested, a list of all configuration information that was set in the PARM member of the domain. The information is displayed in the form key=value, where key is one of the defined parameters, and value the actual value currently active for the domain. For a list of supported configuration entities, see Adapting the Provisioning Manager parameters.

All reported times are in UTC.

Note:

The activation times for the processing mode, domain configuration, and policy might have occurred in a previous run of the Provisioning Manager and might be earlier than the current start time of the Provisioning Manager.

An example of a domain report is:

CPO1008I Domain report generated at 12/22/2012 08:45:10
Provisioning Manager for domain DOMAIN1 started at 12/22/2012 08:40:53
Active processing mode is AUTONOMIC since 12/22/2012 08:40:54
Active domain configuration is DCSAMPLE since 12/22/2012 08:40:54
Active policy is EXAMPLE since 12/22/2012 08:40:54
Code level is 12201
Parm member entries:
 ARM.ElementName = SYSCPO
...
 SystemObservation.UserName = CPOCIM
...
 Topology.Protocol = INTERNAL
...