|
The parameter descriptions are listed in alphabetical order. Default
values are underlined: - ,MF=S
- ,MF=(L,mfctrl)
- ,MF=(L,mfctrl,mfattr)
- ,MF=(L,mfctrl,0D)
- ,MF=(E,mfctrl)
- ,MF=(E,mfctrl,COMPLETE)
- Use MF=S to specify the standard form of the macro, which builds
an inline parameter list and generates the macro invocation to transfer
control to the service.
Use MF=L to specify the list form of the macro. Use the list form
together with the execute form of the macro for applications that
require reentrant code. The list form defines an area of storage that
the execute form uses to store the parameters. Only the PLISTVER parameter
can be coded with the list form of the macro.
Use MF=E to specify the execute form of the macro. Use the execute
form together with the list form of the macro for applications that
require reentrant code. The execute form stores the parameters into
the storage area defined by the list form, and generates the macro
invocation to transfer control to the service.
- ,mfctrl
- Use this output parameter to specify a storage area to contain
the parameters.
To Code: Specify the RS-type name or address (using a register
from 2 to 12) of the parameter list.
- ,mfattr
- Use this input parameter to specify the name of a 1- to 60-character
string that can contain any value that is valid on an assembler DS
pseudo-op. You can use this parameter to force boundary alignment
of the parameter list. If you do not code mfattr, the system
provides a value of 0D, which forces the parameter list to a doubleword
boundary.
- ,COMPLETE
- Use this input parameter to require that the system check for
required parameters and supply defaults for omitted optional parameters.
Note: In the macro expansion you might see some defaults for optional
parameters that are not documented here. The ones that are not documented
do not have any effect on the macro. For example, if SMILE=var were
an optional parameter and the default is SMILE=NO_SMILE then it would
not be documented. However, if the default was SMILE=:-), then it
would be documented because a value would be the default.
- ,RETCODE=retcode
- Use this output parameter to specify a field to contain the return
code. (The return code is also returned in register 15.)
To Code: Specify the RS-type name or address (using a register
from 2 to 12) of a 4-byte field that will contain the return code
when the request has completed.
- ,RSNCODE=rsncode
- Use this output parameter to specify a field to contain the reason
code returned, if applicable. (The reason code is also returned in
register 0.)
To Code: Specify the RS-type name or address (using a register
from 2 to 12) of a 4-byte field that will contain the reason code
(if any) when the request has completed.
- TARGET=target
- Use this input parameter to specify the 64-bit token of the created,
quiesced, or failed member that XCF is to place in the not-defined
state. IXCJOIN (or IXCCREAT) provided this token when it activated
(or created) the member.
To Code: Specify the RS-type name
or address (using a register from 2 to 12) of an 8-byte field that
contains the token.
|