The parameters are:
- JOBNAMES
- The system is to display the name of each job when the job starts
and terminates, and display unit record allocation when the step starts.
If a job terminates abnormally, the job name appears in a diagnostic
message.
- DSNAME
- The system is to display, in mount messages, the name of the
first non-temporary data set allocated on the volume to which the
messages refer. No data set name appears in messages for data sets
with a disposition of DELETE.
Note: This operand
is only effective on the system where the command was processed (system
scope only).
- SPACE
- The system is to display, in demount messages, the available
space on the direct access volume.
Note: This
operand is only effective on the system where the command was processed
(system scope only).
- STATUS
- The system is to display the data set names and volume serial
numbers of data sets with dispositions of KEEP, CATLG, or UNCATLG
whenever they are freed.
- SESS
- The system is to display the user identifier for each TSO terminal
when the session is initiated and when it is terminated. If the session
terminates abnormally, the user identifier appears in the diagnostic
message.
- T
- The system is to display the time (in hours, minutes, and seconds)
along with the user identifier or job name information. When specified, T is activated for all consoles that have MONITOR
turned on.
- L=a, name, or name-a
- The display area (a), console name (name),
or both (name-a) where the system is to present the display.
If you omit this operand, the console on which the MONITOR command
is entered is assumed.
Example:
To display the job name information and the time when each job
starts and terminates, enter:
MN jobnames,T