Input Parameters

Input parameters for the function routine are:

SSOB
SSIB
SSVS

SSOB Contents: The caller sets the following fields in the SSOB control block on input:

Field Name: Description
SSOBID: Identifier 'SSOB'
SSOBLEN: Length of the SSOB (SSOBHSIZ) control block
SSOBFUNC: SSI function code 15 (SSOBVERS)
SSOBSSIB: Address of an SSIB control block or zero (if this field is zero, the life-of-job SSIB is used). See Subsystem Identification Block (SSIB) for more information on the life-of-job SSIB.
SSOBINDV: Address of the function dependent area (SSVS control block)

Set all other fields in the SSOB control block to binary zeros before issuing the IEFSSREQ macro.

SSIB Contents: If you don't use the life-of-job SSIB, the caller must provide an SSIB and set the following fields in the SSIB control block on input:

Field Name: Description
SSIBID: Identifier 'SSIB'
SSIBLEN: Length of the SSIB (SSIBSIZE) control block
SSIBSSNM: Subsystem name — name of the subsystem that this verify subsystem function call is directed to (MSTR).
SSIBJBID: Name of the subsystem to be verified
Note: This is an 8-character field. Because subsystem names can only be 1-4 characters, the subsystem name specified should be left-justified and padded to the right with blank (X'40') characters.

Set all other fields in the SSIB control block to binary zeros before issuing the IEFSSREQ macro.

SSVS Contents: The caller sets the following fields in the SSVS control block on input:

Field Name: Description
SSVSLEN: Length of the SSVS (SSVSSIZE) control block

Set all other fields in the SSVS control block to binary zeros before issuing the IEFSSREQ macro.