When DASD log data set space fills

This step applies to both coupling facility and DASD-only log streams.

The number of DASD log data sets available for log streams in a sysplex depends on whether you use the default (168 per log stream) or have provided additional directory extents in the LOGR couple data set. See Increasing the space available for DASD log data sets for more information.

System logger monitors usage of the available log stream directory space, notifying you as follows if you start to run out of space:

If you are using the DSEXTENT parameter in the LOGR couple data set system logger issues messages IXG261E and IXG262A indicating that usage of directory extents is over 85% and 95% respectively.
If you are using the default number of log data sets allowed for a log stream (168), system logger issues message IXG257I indicating that the data set directory for the log stream is over 90% full.

If you have run out of log stream directory space, off-loads may fail. When this occurs, system logger issues message IXG301I. Offload processing for the log stream cannot complete until more log stream directory space or directory extents are made available. If the last disconnect to a log stream occurs and the offload cannot complete successfully, the log stream is in a failed state. In this case, the log stream is considered 'in use' and there may be a failed-persistent connection to a structure associated with the log stream.

You can make more directory space available for a log stream in one of the ways below. Use the IXCMIAPU utility to run a report of the log stream definitions in the LOGR couple data set to help you with this step. The LIST LOGSTREAM NAME(*) DETAIL(YES) statement outputs information showing which log streams might be using large numbers of data sets and directory extents. See LOGR keywords and parameters for the administrative data utility for more information about IXCMIAPU.

Format another set of LOGR couple data sets with a higher DSEXTENT value and bringing them into the sysplex as the active primary and alternate LOGR couple data sets. See Increasing the space available for DASD log data sets. See Format utility for couple data sets for the IXCL1DSU utility and the DSEXTENT parameter.
Free directory extents currently in use in one of the following ways:
- Use a program that issues the IXGDELET service to delete enough data from the log stream to free up space in the log stream data set directory.
  Some products provide a program to delete log stream data. See Deleting log data and log data sets for deletion programs provided for IBM® products.
- Delete log stream definitions from the LOGR couple data set.
  Identify and delete the definitions for unused or unnecessary log streams. This will free the directory space associated with the log streams, which may free up directory extents for use by other log streams.
Note: Deleting DASD log data sets using a non-system logger method will not work because system logger will still count the data sets toward the data set directory entry limit. You cannot, for example:
- Use a TSO/E DELETE command to delete a log data set.
- Use DFHSM to migrate log stream data sets to tape.