ENQ - Execute form

Syntax

The execute form of the ENQ macro is written as follows:

Syntax	Description

`name`	`name`: symbol. Begin `name` in column 1.

␢	One or more blanks must precede ENQ.

ENQ

␢	One or more blanks must follow ENQ.

(	Note: ( and ) are the beginning and end of a parameter list. The entire list is optional. If nothing in the list is desired then (, ), and all parameters between ( and ) should not be specified. If something in the list is desired, the (, ), and all parameters in the list should be specified as indicated at the left.

`qname addr`	`qname addr`: RX-type address or register (2) - (12).

`,`

`,rname addr`	`rname addr`: RX-type address or register (2) - (12).
,
,E
,S
`,`

`,rname length`	`rname length`: symbol, decimal digit, or register (2) - (12).
,
,STEP
,SYSTEM
,SYSTEMS

)	Note: See note opposite ( above.

,RET=CHNG
,RET=HAVE
,RET=TEST
,RET=USE
,RET=NONE

,RNL=YES
,RNL=NO

,RELATED=`value`	`value`: any valid macro keyword specification.

,LINKAGE=SVC	DEFAULT: LINKAGE=SVC
,LINKAGE=SYSTEM

,MF=(E,`list addr`)	`list addr`: RX-type address or register (1) - (12).

The parameters are explained under the standard form of the ENQ macro, with the following exceptions:

,MF=(E,list addr): Specifies the execute form of the ENQ macro.
list addr specifies the area that the system uses to contain the parameters.