Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Using the AUDIT command or line operator z/OS DFSMS OAM Planning, Installation, and Storage Administration Guide for Tape Libraries SC23-6867-00 |
|
To perform a volume list audit from the MOUNTABLE TAPE VOLUME LIST panel, use the AUDIT command on the command line of the ISMF panel. To perform a library audit from the TAPE LIBRARY LIST panel use the AUDIT line operator next to the tape library name. When you specify a library audit, all volume serial numbers known to that library by the host are audited. Because a library audit and a volume list audit might take a long time to complete, a confirmation panel is displayed whenever these audits are requested. This panel gives you the opportunity to confirm or cancel the audit request. To confirm, type in Y, then press ENTER. See Figure 1 for the Confirm Audit Request panel. Figure 1. Confirm Audit Request Panel
Note: The audit operation can be a lengthy process. During
AUDIT execution, other activity in the library is not quiesced
and AUDIT requests are prioritized lower than other requested functions.
It may take several hours for you to receive
notification that a full library audit or an extensive volume list
audit has completed. Therefore, when scheduling an audit, take work
load and time factors into consideration.
|
Copyright IBM Corporation 1990, 2014
|