To create profiles in the NODES class, perform the following steps:
- Ask your JES system programmer for the information needed to create
the profiles. This includes the following:
- Information for specifying profile names
- For each profile to be created, the UACC to be specified
- For each profile to be created, the values to be translated (to
be specified on the ADDMEM operand)
Note: You should work with your JES system programmer to determine
which user or group should be specified in the OWNER field of the
profiles. This user or group is responsible for maintaining the profiles.
- Use the RDEFINE command to create the profiles. For examples,
see Figure 1, Figure 1, Figure 1,
and Figure 1.
- When you are ready to start using the protection defined
in the profiles, activate the NODES class and activate SETROPTS RACLIST
processing for the class. You can do these two actions in one command:
SETROPTS CLASSACT(NODES) RACLIST(NODES)
Note: - Any time you make a change to a NODES profile, you must also refresh
SETROPTS RACLIST processing for the NODES class for the change to
take effect.
- RACF® does not do any logging
nor issue any messages for the NODES class.