Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
![]() ICH586A z/OS Security Server RACF Messages and Codes SA23-2291-00 |
|
ICH586A IF ANY SYSTEM IS USING THE DATABASE WITH MASTER DATA SET DSNAME ON
VOLUME VOLSER IN DATA SHARING MODE, AND ANY OTHER
SYSTEM CONCURRENTLY USES IT IN NON-DATA SHARING MODE, DATABASE CORRUPTION
WILL RESULT. PROFILE PROFILE-NAME IN CLASS CLASS INDICATES
THAT THIS DATABASE WAS LAST USED IN DATA SHARING MODE, BUT IT IS NOW
TO BE USED IN NON-DATA SHARING MODE. IF THE DATABASE IS NOT BEING
USED BY ANOTHER SYSTEM IN DATA SHARING MODE, SPECIFY 'CONTINUE'. OTHERWISE
SPECIFY 'FAILSOFT' AND THE SYSTEM WILL ENTER FAILSOFT MODE. ExplanationThe APPLDATA field of one or more IRRPLEX_sysplex-name profiles indicates data sharing mode. Either the data set name table (ICHRDSNT) for this system specifies non-data sharing mode, or if the system is enabled for RACF® sysplex communication, and this is not the first system to join the XCF group IRRXCF00, the current mode is communicated by the group data set name table. The data sharing mode indicators within the IRRPLEX_sysplex-name profiles are incompatible with the non-data sharing mode requested for the initialization of this environment. The ICH600A WTOR is issued after this message to obtain a response. Specify CONTINUE if:
Specify FAILSOFT if:
System actionThe system waits for the operators reply. Operator responseRespond to the ICH600A message or contact your systems programmer. System programmer responseIf the identified database is being
used in data sharing mode by another system, the database becomes
corrupted in the following situations:
Note:
If the identified database is not being used in data sharing mode, specify CONTINUE. After initialization uses the RDELETE or RALTER command on the IRRPLEX_sysplex-name profiles as appropriate. The IRRPLEX_sysplex-name profile for this sysplex is updated automatically during initialization. If
the message indicates the backup database, and you did not receive
this message for the primary database, then if the backup database
is intended to be the same as the primary database, and you were able
to specify ‘CONTINUE’ to this message, resynchronize the primary and
the backup databases using "IRRUT200 PARM=ACTIVATE".
Note: Ensure that
the database you are using as the backup database is the correct database
to be using with your primary database. The "IRRUT200 PARM=ACTIVATE"
overlays all the data within the specified backup data set. See z/OS Security Server RACF System Programmer's Guide for
more information about IRRUT200.
If the problem persists, contact
your IBM® support center.Do not use RRSF to propagate the RDEFINE, RALTER, and RDELETE commands to other databases. If automatic command direction is enabled for the GXFACILI class, use the ONLYAT operand (on the RALTER, RDEFINE, and RDELETE commands) when you change IRRPLEX_sysplex-name profiles to prevent this propagation. ONLYAT must be used whether you are altering, creating, or deleting the class GXFACILI IRRPLEX_sysplex-name profiles on a local or remote node. Routing code2 Descriptor code1 ![]() ![]() ![]() |
![]() |