|
- N=
- Required to specify the name for this line up to 8 characters. It must
be different from the N parameter of the RJPTERM statement.
- A=[/]devnum
- Specifies a device number (by 3-digit or 4-digit hexadecimal number).
A slash (⁄) preceding the device number is not required. Device numbers
can be specified by any of the following formats:
ddd
dddd
/ddd
/dddd
ddd or dddd represent a device number. If multiple mains exist,
then this defines the same device identically on all mains. *ALL is not allowed
as a main name.
- A=(main,devnum[,...])
- Specifies a main name and device number (by 3-digit or 4-digit hexadecimal
number).
- F=
- Used to indicate a dial feature for this line (DIAL) or the absence
of a transparency feature for the line (NTRS). If both DIAL and NTRS are selected,
both F parameters are specified, as shown previously.
In dedicated or leased
line environments, transparency feature is assumed on terminals on this line
if you omit this parameter. - DIAL
- Indicates that the line is a switched line. Do not specify F=DIAL if
the line is to be used for the transmission of output restricted to authorized
remote terminals. If not specified, a dedicated (or leased) line is assumed.
- NTRS
- Indicates that the line does not have the transparency feature; if not
specified, the transparency feature is assumed.
- G=
- Indicates a line group name of up to 8 characters, which associates
several lines. If you omit this parameter, eight blanks (no group name) are
used.
- I=
- Indicates the 1-character line interface.
- A
- Refers to the first or only interface of the BSC communications adapter.
- B
- Refers to the second interface of a BSC communications adapter having
the dual communications interface feature.
If you specify an invalid subparameter, JES3 uses the parameter
default.
- I=
- Specifies the mode of operation.
- Y
- Specifies the interrupt mode of operation.
- N
- Specifies the noninterrupt mode of operation.
If you specify an invalid subparameter, JES3 uses the parameter
default.
- O=
- Indicates the line option to have the RJP line start automatically;
the *START operator command is not required. If you omit this parameter, you
must start the line manually using a JES3 *START command.
- P=
- Provides password protection for this line. Password defines a line
password up to 8 characters. This password must be used by any work station
attempting to sign on to this line. If you omit this parameter, JES3 provides
no password protection for this line.
- S=
- Specifies a line baud rate up to 6 characters. If you specify an invalid
subparameter, JES3 uses the parameter default.
- T=
- Indicates a terminal to be assigned to this line. If this parameter
is included, a /*SIGNON card must not be used. T specifies the name (up to
5 characters) of a nonprogrammable terminal. This name must also appear in
the N parameter of an RJPTERM statement and JNAME parameter of a CONSOLE statement.
The T parameter must not be specified when F=DIAL is specified.
|