EZZ9674E

not

Explanation
 Sysplex problem detection has determined that
sysplex processing was not  responsive. 
 tcpstackname is
the name of the TCP/IP stack.
 timevalue is
the number of seconds that sysplex processing was not  responsive.

System action
 TCP/IP continues.  If the GLOBALCONFIG  SYSPLEXMONITOR  RECOVERY option is active
and this stack is not the only member of its TCP/IP sysplex group,
the following RECOVERY actions will occur:  This stack will leave the TCP/IP sysplex group.  
This stack will no longer participate in sysplex distribution
(as a distributor or target) or act as an owner or a backup for DVIPAs.
 All DVIPAs defined on this stack will be deactivated; however, the
DVIPA definitions will be saved.  As the stack leaves the TCP/IP sysplex
group, this operator message will be deleted.  
TCP/IP sysplex problem detection will issue an ABEND with system
code 4C5, reason code TcpSysplexUnresponsive ('0405'x) and capture
an SVC dump.

If the GLOBALCONFIG  SYSPLEXMONITOR  NORECOVERY option is active,
no action will be taken. 

 See  Sysplex problem detection and
recovery in z/OS Communications Server: IP Configuration
Guide for more information.
 See  GLOBALCONFIG statement in z/OS Communications Server: IP Configuration
Reference for the definition of the SYSPLEXMONITOR
parameters.

Operator response
 If RECOVERY is active, save the documentation
taken when the problem occurred.
 If NORECOVERY is active, and
the problem is not corrected, then take a dump of the TCP/IP address
space and dataspaces.
 If RECOVERY is active, then even if the
GLOBALCONFIG SYSPLEXMONITOR AUTOREJOIN option is active, the stack
will not automatically rejoin the TCP/IP sysplex group, due
to the severity of the problem encountered.  Message EZZ9676E will
be displayed if the TCP/IP stack successfully deactivates all DVIPAs
and leaves the TCP/IP sysplex group.  If the problem can be corrected,
then after EZZ967E is displayed, issue the VARY TCPIP,,SYSPLEX,JOINGROUP
command to cause the DVIPA definitions to be processed, and the stack
to rejoin the TCP/IP sysplex group.

System programmer response
 Contact your IBM® support center with the ABEND documentation.
 If the problem cannot be corrected, the stack will need to be restarted
to be able to rejoin the TCP/IP sysplex group.

Module
 EZBXFPDX

Procedure name
  EZBXFPDX