z/OS Communications Server: IP Messages Volume 4 (EZZ, SNM)
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


EZZ8174I

z/OS Communications Server: IP Messages Volume 4 (EZZ, SNM)
SC27-3657-01

EZZ8174I
Error action stack route to destination . masktype mask/prefix . gateway gateway . interface interface . table table

Explanation

An attempt to update the specified stack route table failed.

Note: This message is displayed in uppercase on the console.
In the message text:
action
Possible values are:
adding
The error occurred while attempting to add the route to the stack route table.
deleting
The error occurred while attempting to delete the route in the stack route table.
changing
The error occurred while attempting to change the route in the stack route table.
destination
The IP address of the route destination.
masktype
Possible values are:
mask
The route is an IPv4 route.
prefixlen
The route is an IPv6 route.
mask/prefix
If the route is an IPv4 route, this is the destination's subnet mask. If the route is an IPv6 route, this is the destination's prefix length.
gateway
The IP address of the route's gateway.
interface
The name of the route's outgoing interface.
table
The name of the TCP/IP stack route table in which there was an error adding, deleting, or changing a route. The table value is either EZBMAIN for the main route table or the name of a policy-based route table.

System action

In some cases, OMPROUTE will try the operation again later. For system errors, OMPROUTE will issue an additional message with specific error information and end.

Operator response

Determine whether the error is caused by a bad router or other network error. If so, correct the failing device. If OMPROUTE ends, contact the system programmer.

System programmer response

If OMPROUTE ends, use this message with any other error messages to determine the cause of the problem.

User response

Not applicable.

Problem determination

See the system programmer response.

Source

z/OS® Communications Server TCP/IP: OMPROUTE

Module

EZAORMUP, EZA6RMUP

Routing code

10

Descriptor code

12

Automation

This console message might be issued in cases where OMPROUTE exits abnormally. Automation to notify the operator should be considered so that further investigation can take place.

Example

EZZ8174I ERROR ADDING STACK ROUTE TO DEST 197.11.104.2 , MASK 255.255.240.0 , GATEWAY 
16.2.16.232 , INTERFACE O4ETHL1 , TABLE EZBMAIN
EZZ8174I ERROR CHANGING STACK ROUTE TO DEST 2001:0DB8::104:2 , PREFIXLEN 64 , GATEWAY 
FE80::4 , INTERFACE V6O4ETHL1 , TABLE PRTAB1

Go to the previous page Go to the next page




Copyright IBM Corporation 1990, 2014