Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
EZZ6039I z/OS Communications Server: IP Messages Volume 4 (EZZ, SNM) SC27-3657-01 |
|
EZZ6039I jobname COMMAND command name FAILED,
RCODE=rcode ExplanationThe request did not complete successfully. jobname is the name of the procedure that is used to start the TN3270 server or the job name identifier of the procedure that is used to start the TN3270 server. If you start the TN3270.TNSRV1 server, the jobname value TNSRV1. If you start the TN3270 server, the jobname value is TN3270. command is one of the following:
name is either the LU name that is being activated or deactivated, the debug level requested (Off is currently the only option), or the module name specified on the Abendtrap command, depending on the command. rcode is the return code of the failure. The return codes are documented under message EZZ6035I. System actionNone. Operator responseFor the INACT request, verify that the LU is not already deactivated by using the Telnet INACTLUS display. The LU does not have to already exist in Telnet definitions to be deactivated. It should fail only if it is already deactivated. For the ACT request, verify that the LU is deactivated by using the Telnet INACTLUS display. For the DEBUG request, verify that the option is valid. At this time, OFF is the only valid option. For the ABENDTRAP request, verify that the trap is not already set by using the Telnet PROFILE display. For the QUIESCE, RESUME, and STOP commands ensure that a port number or range includes an active port. If no port number was specified, ensure that only one port is active. System programmer responseNone. ModuleEZAZMTNS |
Copyright IBM Corporation 1990, 2014
|