EZZ0800I

Explanation
 The VIPADISTRIBUTE statement PROCTYPE parameter
is valid only when the DISTMETHOD parameter value is BASEWLM.

System action
 If processing an initial profile or
a VARY TCPIP,,OBEYFILE command, TCP/IP continues, but the The VIPADISTRIBUTE
statement is ignored.
 This message is also displayed
as part of VARY TCPIP,,SYNTAXCHECK processing when the VARY TCPIP,,SYNTAXCHECK
command detects this error in a profile data set.  No changes are
applied to the active configuration by VARY TCPIP,,SYNTAXCHECK processing.

Operator response
 Contact the system programmer.

System programmer response
If this message was displayed
as a result of a VARY TCPIP,,SYNTAXCHECK command:
Change the VIPADISTRIBUTE statement to contain only one of these
keywords.
Issue the command again to verify that you have corrected all
syntax errors in the profile.
Otherwise,
Correct the original profile statement in the VIPADYNAMIC block
to contain only one of these keywords.
Issue the VARY TCPIP,,OBEYFILE command with the changed VIPADYNAMIC
block. 

User response
 Not applicable.

Problem determination
 Not applicable.

Source
 z/OS® Communications
Server TCP/IP

Module
 EZBCFPVA

Routing code
 8

Descriptor code
 12

Automation
This message is directed to the console.
 You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This
message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing.
 Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active
configuration, you might want to adjust your automation to ignore
the configuration messages that are displayed after EZZ0061I and before
EZZ0065I.

Example
  The following
VIPADISTRIBUTE statement would be rejected because PROCTYPE was  specified
with a DISTMETHOD parameter value other than BASEWLM:
 VIPADISTRIBUTE  PROCTYPE DISTMETHOD ROUNDROBIN 201.2.10.11  PORT 4011  DESTIP  ALL
VIPADISTRIBUTE PROCTYPE CP 10 ZAAP 90 DISTMETHOD ROUNDROBIN 201.2.10.11 PORT 4011 DESTIP ALL