EZZ0713I

Explanation
 An IPv4-mapped IPv6 address cannot be specified
on the IP configuration  statement at line lineno.
 In the message
text:ipv6addr 
The IPv6 address
lineno
The line number in the profile where the error was found

See the z/OS Communications Server: IP Configuration
Reference for more information about the IP configuration
statement where the error was found.

System action
 If processing an initial profile or
a VARY TCPIP,,OBEYFILE command, TCP/IP ignores the statement. TCP/IP
continues.
This message is also displayed as part
of VARY TCPIP,,SYNTAXCHECK processing when the VARY TCPIP,,SYNTAXCHECK
command detects this error in a profile data set. No changes are applied
to the active configuration by VARY TCPIP,,SYNTAXCHECK processing.

Operator response
 Contact the system programmer.

System programmer response
Correct the statement. 
If this message was displayed as a result of a VARY TCPIP,,SYNTAXCHECK
command, issue the command again to verify that you have corrected
all syntax errors in the profile. Otherwise, issue the VARY TCPIP,,OBEYFILE
command to rerun the configuration statement.

Module
 EZACFPV6

Automation
This message is directed to the console.
You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This
message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing.
 Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active
configuration, you might want to adjust your automation to ignore
the configuration messages that are displayed after EZZ0061I and before
EZZ0065I.

Procedure name
  processInterface

Example
 EZZ0713I IPV4-MAPPED IPV6 ADDRESS OF ::FFFF:192.0.2.128 ON LINE 82 CANNOT BE SPECIFIED