EZZ0708I

Explanation
 A permanent loopback address cannot
be specified on the configuration statement at the specified line
number in the TCP/IP profile. 
 In the message text: ipaddr
The IPv4 or IPv6 permanent loopback address (127.0.0.1 or ::1)
lineno
The line number in the profile or the VARY TCPIP,,OBEYFILE command
data set where the error was found

System action
 TCP/IP ignores the statement. TCP/IP
continues.
This message is displayed as part of VARY
TCPIP,,SYNTAXCHECK processing when the VARY TCPIP,,SYNTAXCHECK command
detects this error in a profile data set. No changes are applied to
the active configuration by VARY TCPIP,,SYNTAXCHECK processing.

Operator response
 Contact the system programmer.

System programmer response
 Correct the statement.  Rerun the
profile.

Module
 EZACFPV6, EZACFPR2

Automation
This message is directed to the console.
 You can use automation to detect and respond to TCP/IP profile errors
reported during initial profile and VARY TCPIP,,OBEYFILE processing.
This
message can also be displayed during VARY TCPIP,,SYNTAXCHECK processing.
Because the VARY TCPIP,,SYNTAXCHECK command does not affect the active
configuration, you might want to adjust your automation to ignore
the configuration messages that are displayed after EZZ0061I and before
EZZ0065I.

Procedure name
  processInterface,
processSourceIP

Example
 EZZ0708I PERMANENT LOOPBACK ADDRESS ::1 ON LINE 27 CANNOT BE SPECIFIED