Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Panel identifier z/OS ISPF User's Guide Vol II SC19-3628-00 |
|
You can specify that you want to display panel identifiers in either of two ways:
When you select "Panel identifier" from the Identifier pull-down, the Panel Identifier panel is displayed. If you select the "Display panel identifier" option, the panel identifier is set to On. The identifier will now display in the panelid area. Deselect this choice (or issue the PANELID OFF command) to set the panel identifier to Off. This setting only applies to the current ISPF session. To retain the setting across ISPF sessions, select "Default setting for panel identifier". This figure shows the top portion of the ISPF Settings panel displayed with the panel identifier set to On. Figure 1. Panel displayed with the panel
identifier set to on
Note: The commands SYSNAME, USERID, PANELID, and SCRNAME share the
same 17-character area at the start of the Title line. If more than
one of these commands are specified, ISPF displays as many as will
fit, in this order of priority: SYSNAME, if specified, is always displayed.
Then, as long as there is enough room, USERID is displayed, then PANELID,
then SCRNAME.
|
Copyright IBM Corporation 1990, 2014
|