Ending an FSA (basic mode)

z/OS Infoprint Server Operation and Administration

Ending an FSA (basic mode)

z/OS Infoprint Server Operation and Administration
SA38-0693-00

Ending an FSA (basic mode)

If you are not able to stop an FSA with the commands described in Stopping an FSA (basic mode), in both JES2 and JES3, you can use the MODIFY command with the FORCE parameter. The syntax of this command is:

Syntax

{MODIFY | F} fss_name,FORCE,fsa_name

fss_name: Specifies the name of the FSS that manages the FSA. The fss_name parameter must match the FSSNAME parameter of the JES FSSDEF statement for the FSS.
FORCE: Specifies that the FSA is to be stopped.
fsa_name: Specifies the FSA to be stopped.

Tip:

IP PrintWay™ writes message ANFM027I when the FORCE parameter is processed. If the FSA is tracing to an external trace data set when the FORCE parameter is used, an abend might occur when the FSS address space ends.

If the MODIFY command is unsuccessful on JES3 systems, enter this JES3 command:

  *FAIL,fsa_name

Notices | Terms of use | Support | Contact z/OS | zFavorites