Using VTAM HALT commands
When you enter a VTAM® HALT
command, NetSpool does
one of these actions, depending on the type of HALT command you entered:
- Standard HALT
The HALT command causes all VTAM sessions to end normally. New sessions are
not allowed to start. No data is lost. NetSpool creates output data sets
with all received data. NetSpool places all started printer LUs in
the WAITING state, periodically (every 60 seconds) attempting to restart
the printers.
- HALT QUICK
The HALT QUICK command causes all VTAM sessions to end immediately. New sessions are
not allowed to start. No data is lost. NetSpool creates output data sets
with all received data. NetSpool places all started printer LUs in
the WAITING state, periodically (every 60 seconds) attempting to restart
the printers.
- HALT CANCEL
The HALT CANCEL command causes all VTAM sessions to end immediately.
New sessions are not allowed to start. No data is lost. NetSpool creates
output data sets with all received data. The NetSpool started task stops, returning
to the operating system.
|