Procedure for specifying attributes
On the Allocation panel, specify these fields:
- Spool allocation values heading: Specify
the JES job-selection values for IP PrintWay™:
- If you run IP PrintWay extended
mode, specify the same job-selection values that are specified
in the IP PrintWay job selection
rule. For example, if the job selection rule specifies class P, specify
P in the CLASS field.
- If you run IP PrintWay basic
mode, specify the same work-selection values that are specified in
the JES definition for the IP PrintWay FSA.
For example, if the JES definition specifies class P and destination
PRT001, specify P in the CLASS field and PRT001
in the DEST field.
Also, specify:
- Values for separator pages heading:
- Address, Building, Department, Name, Room, Title:
Specify the values that IP PrintWay exits
(for example, the Begin Data Set) can print on separator pages. For
information about IP PrintWay exits,
see z/OS Infoprint Server Customization.
- Title: Specify the subject line for emails
(email protocol), or the title passed to LPDs (LPR protocol). You
can specify up to 60 characters, including blanks and any other printable
characters.
- Other values heading:
- Notify: Specify
up to four user IDs that IP PrintWay notifies
when a data set has been successfully or unsuccessfully transmitted,
or when IP PrintWay deletes
the data set from the JES spool.
- Copies:
Specify the number of copies to be printed. Allowed values are 1 to
32640. The default value is 1.
Guidelines:
- VTAM® protocol: This field
does not apply when you run IP PrintWay basic
mode. Only one copy prints.
- Email protocol: This field does not apply. Only one copy is sent.
- IPP protocol: Some IPP printers do not support the copies IPP
job attribute. In this case, only one copy prints.
- LPR protocol: If only one copy prints, deselect the Optimize
copies field.
- If a copy does not start on a separate page, specify printer commands
to start a new page. For information, see Specifying printer commands to print on a new sheet of paper.
- This field does not apply to output data sets that z/OS® batch jobs create because
JES sets a default of one copy.
- Duplex:
Specify the type of duplexing.
Guidelines:
- LPR, direct-sockets, VTAM,
email protocols: This field does not apply.
- IPP Protocol: The IPP server must support the sides IPP
job attribute. If it does not, the printer's default is used.
|