For a bar chart

GDDM-PGF V2R1.3 Interactive Chart Utility

For a bar chart

GDDM-PGF V2R1.3 Interactive Chart Utility
SC33-0328-01

Set Bar Chart Type to 1 (panel 1.4) and set Gap between Bars to -100. (In the example below, the Gap between sets of bars was also altered, to 50.) Then proceed as follows:

Panel

Action taken

2.2

Multiply one data group by -1.

5.2

Set Axis Orientation to 2.

4.7

(Y Axis) set a reference line at 0.

4.8

(Y Axis) set a datum line at 0 (as reference lines are covered by shading).

4.3

Set Axis Range so that 0 is in the middle. (-30 to 30 was used here.)

4.4

Set Label Type to 2.

4.4.1

Type in the x-axis labels. If needed, adjust the Major Tick Mark Interval (panel 4.5) to control their number.

Figure 227. Profile chart form of a bar chart

Notices | Terms of use | Support | Contact z/OS