|
Loading a chart lets you work on it again, or use it as the basis of a new
chart.
- Make sure you are in the Home Panel. (It says INTERACTIVE CHART
UTILITY - HOME PANEL at the top.) If you are not, press PF12.
- Press PF2.
- If the panel says SAVE AND LOAD CHART at the top:
- Set What is to be done to 1, set What part of chart to 3, and type
in the name of the chart you want to load.
You can only work on one chart at a time. If you try to load a
chart and you already have one that you haven't saved, you will
get a warning message. Either save the original chart before
getting the next one, or set Replace to Yes (you will lose any
changes that you made to the original chart).
- Press ENTER. You will get a message saying 'LOAD' SUCCESSFUL FOR
CHART FORMAT AND DATA. The chart will be shown in the preview
chart, if you have it set on.
If the panel says DIRECTORY at the top, you have set Usage of
Directory Panel to 2 - Advanced Mode in the Menu Control panel. Carry
on as follows:
- On the top line of the panel, type in R for RESTORE and the name
of the chart so that the line looks like the one below.
R__ *** NMCHART
- Press ENTER. You will get a message saying 'LOAD' SUCCESSFUL FOR
CHART FORMAT AND DATA. The chart will be shown in the preview
chart if you have it set on.
|