dsphagrp (display HA group status)
Displays the status of the appliances in the high availability (HA) group.
Purpose
You can use the dsphagrp command to display the status of each appliance in
an HA group. The status returned can be Online
, Offline
, or
Standby
. The status is Online
when the appliance is operating
normally, Offline
when some fault has occurred, or Standby
when the appliance has been suspended by using the sethagrp -s command.
If you are upgrading an 8.0 or 9.0 appliance to 9.1, the migration
pending
status is displayed until you run the sethagrp -u
command to
upgrade each HA queue manager, and the other appliance is upgraded to Version 9.1 too.
Syntax
Parameters
None.Usage Notes
- This command must be run from the IBM® MQ administration mode. If the system is in the IBM MQ administration mode the prompt includes
mqa(mqcli)#
. To enter the IBM MQ administration mode, entermqcli
on the command line. To exit the IBM MQ administration mode, enterexit
on the command line.
Examples
- The following command displays information about the high availability group:
dsphagrp