You might need to replace the SMP processor cable. Use the procedure
in this section to perform this task.
To replace
the SMP processor cable, complete the following steps:
Disconnect the power source from the system units by unplugging
the system units.
Note: The system units might be equipped with
secondary power supplies. Before continuing with this procedure, ensure that
all power sources to the system units have been disconnected completely.
Place the SMP processor cable into position over the system units
so that the connectors align with the processor cards in each unit.
If you replaced the SMP processor cable as part of another procedure,
return to that procedure now. If you replaced it because it was not functioning
correctly, verify that the new cable is functional. See Verify the installed part.