You might need to use the Hardware Management Console to facilitate
removing a part from your managed system. Use the procedure in this section
to accomplish this task.
To use the Hardware Management Console user interface to remove
a part in a system or expansion unit that is managed by a Hardware Management
Console (HMC), follow these steps:
- In the navigation area, expand the Management
Environment.
- Expand the managed system in which you are replacing a part.
- Expand Service Applications.
- Select Service Focal Point.
- In the contents area, select Install/Add/Remove Hardware.
- In the Install/Add/Remove Hardware window, click System
Processor.
- From the Selected menu, select Remove FRU.
- In the Installed enclosure types field, select the system
or expansion unit from which you are removing a part.
- In the Available FRU types for selected enclosure, select the part
you are removing.
- Click Next.
- Follow the instructions to remove the part.
Note: The
HMC might open the information center instructions for removing the part.
If so, follow these instructions to remove the part.
Remove a part using the HMC Version 7 or later
- In the navigation area, expand Systems Management.
- Expand Servers.
- Select the managed system from which you are removing a part.
- In the Tasks area expand Serviceability.
- Expand Hardware.
- Select Remove FRU.
- In the Add/Install/Remove Hardware - Remove FRU, Select FRU
Type window select the system or enclosure from which you are
removing the part from the list.
- Select the type of part you are removing from the menu and click Next.
- Select the location of the part you are removing and click Add.
- Once the part is listed in Pending Actions click Launch
Procedure and follow the instructions to remove the part.
Note: The
HMC might open external instructions for removing the part. If so, follow
these instructions to remove the part.