The backup and restore capabilities of the mmcesdr command can be used
when there is no secondary cluster and the user still wants to protect protocol and export services
configuration information. The independent fileset used to store protocol and export services
configuration information can be backed up using IBM Spectrum Protect™ software and then restored if it ever needs to be
restored to the cluster.
Note: The following steps only describe how to back up and
restore the protocols and CES configuration information. The actual
data contained in protocol exports would need to be backed up and
restored separately.
- On the primary cluster, use the following command to back up the configuration
information:
mmcesdr primary backup
The system displays output similar to the following:
Performing step 1/2, configuration fileset creation/verification.
Successfully completed step 1/2, configuration fileset creation/verification.
Performing step 2/2, protocol and export services configuration backup.
Successfully completed step 2/2, protocol and export services configuration backup.
For backup, you can use IBM Spectrum
Protect (formerly
known as Tivoli® Storage Manager) or some other tool. For
example, you can use mmbackup as follows:
mmbackup configuration_fileset_link_point --scope inodepace -t full
- On the primary cluster, restore data from the off cluster storage into the configuration
fileset. If mmbackup was used to back up the configuration fileset, the IBM Spectrum
Protect command to restore is similar to the
following:
dsmc restore -subdir=yes "configuration_fileset_link_point /*"
- On the primary cluster, use the following command to restore the configuration
information:
mmcesdr primary restore
The system displays output similar to the following:
Restoring cluster and enabled protocol configurations/exports.
Successfully completed restoring cluster and enabled protocol configurations/exports.
In some cases, running the mmcesdr primary restore command might display
the following error message:
Saved configuration file does not
exist.. In this case, do the following:
- On the primary cluster, remove the file authentication and then add it again:
Note: If you want to perform a restore as part of a failback (either to an old primary cluster or a
new primary cluster) and want to re-create the file configuration/exports, use one of the following
commands:
mmcesdr primary restore
or
mmcesdr primary restore --file-config
--recreate.