Configuring static routes

Besides configuring static routes, you can also use this page to set the default gateway.

About this task

This task is only necessary for networks that contain an additional network segment between the user segment and the appliance.

Procedure

  1. From the top menu, select Manage System Settings > Network Settings > Static Routes.
  2. Select the route table to edit from the Route Table For field. You can use these route tables to configure routes that are specific to requests destined for a particular local IP address. Use the Default table if specific local IP address control is not required.
  3. Take one of the following actions:
    • Click New to create a route.
    • Select an existing route, and then click Edit to change the settings.
    • Select an existing route, and then click Delete to remove it.
  4. Define the following information in each field:
    • Enabled
    • Destination
      Note: To make this route the default gateway, enter Default in the Destination field.
    • Gateway
    • Metric
    • Interface
  5. Click Save Configuration.
Parent topic: Network Settings