Integrating TADDM with IBM Tivoli Monitoring via OSLC Automation
TADDM can be integrated with IBM® Tivoli® Monitoring by using OSLC Automation. If you want to integrate TADDM with IBM Tivoli Monitoring 6.3, it is advised to use OSLC Automation. The old method of integration with the use of IBM Tivoli Monitoring Scope sensor is deprecated and will be removed from future releases.
TADDM uses the IBM Tivoli Monitoring infrastructure
in the following two ways:
- TADDM obtains the list of IBM Tivoli Monitoring endpoints from the Tivoli Enterprise Portal Server via OSLC Automation Session.
- TADDM both runs CLI commands on the target systems for the sensors in Level 2 and Level 3 discovery and captures the output of those commands.
Prerequisites:
- If you are using Windows 7 and above you will need:
-
1. PowerShell version 2+
2. TEMS SOAP URL
3. Check that you can connect to both TEMS and TEPS
The following table provides steps, which you must complete to successfully enable integration of
TADDM with IBM
Tivoli Monitoring via OSLC Automation.
Step | Details |
---|---|
Configure ITM Tivoli Enterprise Monitoring Server (TEMS) and ITM TEPS hosts | Configuring ITM Tivoli Enterprise Monitoring Server (TEMS) and ITM TEPS hosts |
Install OSLC Execute Automation Service Provider on IBM Tivoli
Monitoring Note: Make sure that you meet all prerequisites specified in Prerequisites for installing OSLC Execute Automation Service Provider on IBM Tivoli Monitoring.
|
Installing OSLC Execute Automation Service Provider on IBM Tivoli Monitoring |
Configure TADDM to use OSLC Execute Automation Service Provider | Configuring TADDM to use OSLC Execute Automation Service Provider |
Configure TADDM for discovery:
|
Configuring for discovery over OSLC Automation Session |
After you complete these steps, you can run a discovery by using ITM OSLC Execute Automation Service Provider.