You must provide property
information about the JDBC data sources for the global configuration database (GCD). Content Platform Engine uses the data source
information to connect to and update the GCD.
Before you begin
Ensure
that the application server instance is running or stopped, depending
on its type:
Table 1. Required application
server stateOption |
Description |
WebSphere® Application
Server |
Start
the application server instance if it is not already running. |
JBoss Application Server |
Stop
the application server instance. |
WebLogic Server |
Start
the application server instance if it is not already running. |
Important: Do not change the JDBC data source
or JDBC XA data source.
Procedure
To configure the JDBC settings:
- Open your completed
Installation and Upgrade Worksheet file.
Tip: In
the worksheet file, verify that the command is enabled. To view only Configuration Manager values, filter
by CM: Configure GCD JDBC Data Sources in the Installation
or Configuration Program column.
- If your configuration profile
is not open in Configuration Manager, open the profile.
- Right-click Configure
GCD JDBC Data Sources in the profile pane and select Edit
Selected Task.
- Enter the property values for
your database by using the values in your worksheet.
- Optional: (WebSphere and WebLogic only) Click Test
Database Connection to test the connection to the database
by using the database user name, database server name, database name,
port number, and password that you provided. The test
does not create the data sources.
(WebLogic
only) If the test fails, complete the following substeps to reset
the data source parameters before attempting the database connection
test again:
- Start the WebLogic Server administrative
console.
- Click .
- Select the check box for the data source and then click Delete.
- Click Activate Changes.
- Click Save to
save your changes.
- Ensure that the task
is enabled. When the task is disabled, the task name includes the
text (disabled). To
enable the task, select Configure GCD JDBC Data Sources
(disabled) in the profile pane, and then either right-click
and click Enable Selected Task from the menu,
or click the Enable the Selected Task icon
in the task toolbar.
- Apply the JDBC property settings
by right-clicking Configure GCD JDBC Data Sources in
the profile pane, and selecting Run Task. Running the configuration task can take several minutes. The
task execution status messages are displayed in the console pane below
the JDBC properties.
- Close the Configure
GCD JDBC Data Sources task pane. In this
step, you created the GCD data sources. You create the initial object
store data sources later in the configuration process.