Disabling and enabling data capture
Recording of data is enabled by default, but takes effect only if you define a DataCaptureSource configurable service. You can disable recording for all of the data capture sources on an integration server by modifying the integration node runtime properties for that integration server.
Before you begin
About this task
Procedure
You can use IBM Integration Bus runtime commands to disable recording for your integration server. Complete the following steps.
Review and edit the current setting on the ComIbmDataCaptureManager
resource manager.
- If you are using the runtime commands, complete the following
steps:
- Enter the following command on an IBM Integration Bus command line, where integrationNodeName is the name of your integration node and integrationServer is the name of the integration server:
mqsichangeproperties integrationNodeName -e integrationServer -o ComIbmDataCaptureManager -a
The command produces a response similar to this example:ComIbmDataCaptureManager uuid='ComIbmDataCaptureManager' userTraceLevel='none' traceLevel='none' userTraceFilter='none' traceFilter='none' enabled='true'
- Change the enabled property to false, by entering
the following command:
mqsichangeproperties integrationNodeName -e integrationServer -o ComIbmDataCaptureManager -n enabled -v false
Your change takes effect immediately.
What to do next
When you are ready to start recording again for your integration server, use the mqsichangeproperties command to change the enabled property to true, and restart the integration node.