MODIFY RTP command

Abbreviations

Purpose

The MODIFY RTP command causes VTAM® to search for the best high performance routing (HPR) route, based on transmission group weight, between the two endpoints of a rapid transport protocol (RTP) connection. If an equal or better route is found, the connection is switched to the better route. If the current route is the best route, a path switch still occurs, but the switch is made to the same route.

Operands

procname

The procedure name for the command. If procname in the START command was specified as startname.ident, where startname is the VTAM start procedure and ident is the optional identifier, either startname.ident or ident can be specified for procname.

If procname in the START command was startname, startname must be specified for procname.

ID=rtp_pu_name

Specifies the name of a PU that represents a rapid transport protocol (RTP) route. This operand is required.