A7A
Explanation
Initialization of the service processor interface (SPI) failed. The reason code appears in the
program status word (PSW). The address portion of the PSW contains
X'x0rrrA7A', where rr is the
reason code. The following reason codes explain the failure:
- Code
- Explanation
- 001
- The service processor interface task could not be attached.
- 002
- The recovery environment could not be established.
- 004
- The required service processor facilities are not installed.
- 006
- The service processor is busy during system initialization.
- 007
- A service processor malfunction occurred during system initialization.
- 008
- Service processor damage is detected during system initialization.
- 009
- Service processor interface component trace could not be initialized.
- 00A
- The service processor interface could not load a module.
- 00B
- The service processor interface could not obtain storage.
- 00C, 00D, 00E, 00F
- An internal error occurred.
- 011
- The enabled wait PSW was used for looping during a disabled write to operator.
- 013
- An internal error occurred.
System action
The system loads non-restartable wait state X'A7A'.
Operator response
For reason code X'06', X'07', or X'08', contact hardware support. For other reason codes, notify the system programmer.
System programmer response
Search problem reporting databases for a fix. If no fix exists, contact the IBM® Support Center.
Source
Service processor interface