Syntax
The syntax for the SETHS command is:
|
- ENABLE
- Enables the HyperSwap® function for all PPRC pairs.
- DISABLE
- Disables the HyperSwap function for all PPRC pairs.Note: The DISABLE status does not persist across a sysplex-wide IPL.
- RESUMEIO
- Resumes normal I/O activity to all DASD devices that have been stopped by Basic HyperSwap because the STOP option was used. See message IOSHM0303I for the explanation of the STOP option. These devices can be identified by the device status DEVICE STOPPED BY HYPERSWAP when the DISPLAY M=DEV(nnnn) command is issued.
- UNBLOCK
- Unconditionally reset the HyperSwap inhibited by programmatic blocking condition.
- SWAP
- Initiates a HyperSwap for all PPRC pairs.
- NAME(session_name)
- Optionally selects a specific configuration (replication session) for the planned HyperSwap. If NAME
is not specified, the planned HyperSwap will be
attempted using the current preferred configuration.
- session_name
- The 16-character configuration name.
- UNFENCE
- Unconditionally remove the soft fence condition for all DASD devices.