APPCDATA STATUS subcommand output

The APPCDATA STATUS subcommand displays the status of the APPC address space as a message. The APPCDATA STATUS SUMMARY and DETAIL reports are identical. Figure 1 is an example of the APPCDATA STATUS DETAIL.

Figure 1. Example: APPCDATA STATUS subcommand output

Detail Report for STATUS
------------------------

The APPC/MVS component was ACTIVE

Information displayed in this report includes:

Status Message

The message that displays the status of the APPC address space at the time of the dump. The status message is one of the following:

STARTUP: The APPC address space was being initialized at the time of the dump.
ACTIVE: At the time of the dump, the APPC address space was fully initialized and capable of processing transactions.
NOT ACTIVE: At the time of the dump, the APPC address space was unable to process transactions.
TERMINATION/RESTART: The system ended the APPC address space because of a critical error. At the time of the dump, the APPC address space was in the process of restarting.
TERMINATION/NORESTART: The system ended the APPC address space. The APPC address space did not attempt to restart itself.
CANCELLED: The system ended the APPC address space because of an operator CANCEL command.
MEMORY TERMINATION: The system ended the APPC address space and its memory in response to either an operator FORCE command or a critical error.
UNKNOWN: At the time of the dump, the status of the APPC address space could not be determined.