IEC161I (return code 250) rc[(sfi)]-ccc,jjj, sss,ddname,dev,ser,xxx, dsname,cat
Explanation
For general information about message IEC161I, see the explanation for return code 001.
Specific information
for this return code: One of the following errors occurred:
- VSAM RLS processing was requested from an address space currently
identified as being a commit protocol application:
- ccc = 565 - The required SUBSYSNM parameter was not specified on the ACB.
- ccc = 566 - The SYSNMVAL value mapped by the IFGSYSNM macro does not match the value currently identified for the address space.
- VSAM RLS processing was requested from an address space which
has not been identified as being a commit protocol application:
- ccc = 568 - The ACB specified the SUBSYSNM parameter for a non-commit protocol application.
System action
OPEN processing ends for the data set. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 202 (X'C1').
Programmer response
- Verify that the ACB SUBSYSNM parameter is valid for the identified address space.
- Remove the ACB SUBSYSNM parameter.
Module
IDAV192A
Routing code
11
Descriptor code
6