IEC161I (return code 037) rc[(sfi)]-ccc,jjj, sss,ddname,dev,ser,xxx, dsname,cat
Explanation
For general information about message IEC161I, see the explanation for return code 001.
- rc - catalog return code
- crs - catalog reason code
- cmi - catalog module name that detected the error
- ccc = 217 - Preformat call to update catalog failed.
- ccc = 220 - Call to striping extend RC = 12, RSN = 1. First catalog locate had an error.
- ccc = 223 - Call to striping extend RC = 12, RSN = 2. Set VVRIF had an error.
- ccc = 224 - Call to striping extend RC = 12, RSN = 3. Third catalog call (extend) had an error.
- ccc = 227 - Call to striping extend RC = 12, RSN = x. Unknown error. Call to extend had an error.
System action
OPEN, CLOSE, or EOV processing ends for the data set. CLOSE (TYPE=T operand) processing continues, if possible. The error flag (ACBERFLG) in the ACB (access method block) for the data set is set to 148 (X'94').
Programmer response
If the error occurred during OPEN, CLOSE (TYPE=T), or EOV processing, rerun the job. If the error persists, restore the catalog and all volumes controlled by the catalog from synchronized restore tapes. If the error occurred during CLOSE processing, and the data set was open for output processing, use the access method services VERIFY command to ensure that the end-of-file marker is properly addressed in the data set's entry in the catalog; then rerun the job. If the problem persists, restore the catalog and all volumes controlled by it from synchronized restore tapes.
Module
IDA0192C, IDA0557B, IDA0557E, IDA0557X, IDAV192C, IDAV557A, IDAV557X
Routing code
11
Descriptor code
6