IEC603I VTOC ERRORS MAY EXIST ON dev,ser,cde, rsnc
Explanation
- Cde 0
- An I/O or unexpected CVAF error return code error occurred in the DADSM routines Allocate, Extend, Scratch or Partial Release. The routine ended processing, thereby leaving the VTOC in a partially updated state.
- Cde 4
- The Scratch or Partial Release function of DADSM discovered that the space it was returning to the chain of Format-5 DSCBs which describe the free space on the volume was already present in a format-5 DSCB. Although Scratch or Partial Release was able to successfully process this incorrect data, thereby correcting the situation, other problems may exist on the VTOC.
- Cde 8
- An I/O error or unexpected CVAF error return code occurred in the DADSM routines (Allocate, Extend, Scratch, Partial Release, Rename) during updating of the VTOC index or the VTOC on an indexed VTOC volume, thereby leaving the indexed VTOC in a partially updated state. DADSM processing is ended.
- 027
- The index data set is full.
- dev
- The device number of the specified device.
- ser
- The volume serial number.
- cde
- The code.
- rsnc
- The reason code.
System action
For codes 0 and 8, if the error occurred during allocation, the job is ended. If the error occurred in the middle of a job extending the space allocated to a data set, or a job releasing unused allocated space while closing a data set, the job is abnormally ended. If the error occurred while scratching or renaming a data set, an I/O error is returned. For code 0 the DIRF bit in the format-4 DSCB is set to one; for code 8 the VRF data set is left in the VTOC index map to indicate that Active VTOC Recording Facility (VTOC) may be in error. A system dump is taken if the cause of the error is an unexpected CVAF error return code.
If code is 4, VTOC updating continues, and if no further errors are encountered, the job continues processing.
The DIRF bit in the format-4 DSCB is set to one.
Operator response
Report this message to the system programmer.
For error code 0 or 4, either message IEC602I or message IEC604I will be issued the next time allocation is attempted on this volume. For code 8, which refers to an indexed VTOC, message IEC605I will be issued when the next DADSM VTOC updating function (Allocate, Extend, Scratch, Partial Release, Rename) is performed.
System programmer response
If the error recurs and the program is not in error, look at the messages in the job log for more information. Search problem reporting data bases for a fix for the problem. If no fix exists, contact the IBM® Support Center. Provide the SYSOUT output for the job.
Programmer response
Some attempt should be made to analyze the state of the VTOC on the affected volume.
Source
DFSMSdfp
Routing code
4,10
Descriptor code
4