IEC191I 50D-rc, INVALID PARAMETER LIST SUPPLIED TO OPEN MACRO, DCB ADDRESS = dcb
Explanation
The OPEN parameter list contains an incorrect data control block (DCB) address.
The hexadecimal reason code explains
the error:
- Return Code
- Explanation
- 1C
- The execute form of the OPEN macro specifies MODE=31, but the parameter list specifies, or defaults to, MODE=24.
- 20
- The execute form of the OPEN macro specifies MODE=24, but the parameter list specifies MODE=31.
In the message text:
- rc
- The reason code.
- dcb
- The DCB address.
System action
The task ends.
Programmer response
If you generated the parameter list by using the list form of the OPEN macro, change the mode specification to be consistent on both the MF=L and MF=E forms of the OPEN macro. Otherwise, to have consistent modes, you may either change the form of the parameter list or change the mode specification on the MF=E form of the OPEN macro.
Source
DFSMSdfp
Module
IGC0001I
Routing code
11
Descriptor code
6